Product Overview
This heavy duty Trackbar mount will replace your factory mount and allow for a 2.5 inch-3.5 inch Stretch forward of the factory position. Perfect for use with our TJ 1 Ton Axle Swap for added clearance.
Details:
- TJ/ LJ Trackbar Mount
- Designed to curve the factory frame and align the track bar position
- Locates off a factory frame hole for easy positioning
- Tracbar bracket can slide on frame plate forward or backward until you find the best location with your set up
- 3 hole locations for finding the right steering/track bar geometry. 1.3 inch in between each hole
- If using the top two holes, you can cut off the bottom of the bracket for higher clearance
- 1.75 inch mounting width to fit our 7/8 inch X 3/4 inch Rod Ends With High Misalignment Spacers. (Will Not work with a Factory Replacement Joint)
- CNC laser cut and CNC bent from 1/4 inch steel for precision fit and heavy duty use
- Sold as kit
Note:
- This kit requires general welding and fabrication skills including welding to the cast center section. Welding should only be done by a competent welder. Artec Industries implies no guarantees or warranties and is Not liable for improper installation.
- Some grinding and fitment may be required when installing this kit. Every axle varies slightly and some fabrication may be required.
Fitment:
- 2006 - 2006 Jeep Wrangler 65th Anniversary Edition
Vehicle Type: Jeep
Location: Rear
Material: Steel